Thru-bed exhaust tips

The dual exhaust is routed under the cab and exits thru the bed, ahead of the rear tires on each side. I cut out the bed and put a little flange around the cut out to dress it up.

Flange along bottom edge of the bed, just ahead of the rear tire on the driver's side.

This is the pipe I fabricated that attached to the exhaust manifold. I had to fit it down between the engine block and the frame rail, then it had to go under the frame rail between the torsion bar and the frame to exit to the rear.

This is the exahust pipe mounted and the rough cut out into the bed prior to putting the flange around the cut out.

Exhaust tip is tucked back a little, inside the flange and cut out of the bed.

Looking down on the flange the exhaust tip is just visible. I turned the tips down just a little too so it blows dry dirt around on the ground.